Back buckle photovoltaic panel installation method

How do I install a solar photovoltaic system?

Installing solar photovoltaic systems requires specialized skills and knowledge. Installation should only be performed by qualified personnel. Before installing a solar photovoltaic system, installers should familiarize themselves with its mechanical and electrical requirements.

Which direction should a photovoltaic module be installed?

When installing photovoltaic modules in the northern Hemisphere, the optimal installation direction of the module is to face south; When installing photovoltaic modules in the Southern Hemisphere, the optimal installation direction of the module is to face north. Serial connected PV modules should be installed in the same orientation and Angle.

Can a racking system be used to ground a PV module?

This racking system may be used to ground and/or mount a PV module complying with UL 1703 only when the specic module has been evaluated for grounding and/or mounting in compliance with the included instructions. The system is a non-separately derived system.

How do I connect a solar stack module to a pedestal?

Modules should be bonded to the Solar Stack pedestals with the manufacturer approved middle/end clamps. Grounding hardware (as a part of the module clamps) forms secure electrical bonds with both the module and the pedestal, resulting in many parallel grounding paths throughout the system.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.

How to install a photovoltaic light fixture?

The fixture shall be installed within the scope authorized by Suntech. The inside side of the fixture and the side of the photovoltaic module should be completely fitted. In any fixture installation mode, the fixture must not touch the glass or deform the frame of the bracket or module.