Photovoltaic inverter startup instructions

Step 1: Plan the Installation SiteStep 2: Mount the Solar InverterStep 3: Make Electrical ConnectionsStep 4: Install Optional System Shutdown SwitchStep 5: Install Energy MeteringStep 6: Complete the InstallationStep 7: Configure the System.

The start-up procedure is as follows: 1) Set the external DC disconnect, if present, (for the photovoltaic panels) to ON 2) Set the external AC disconnect (for the grid) to ON.

Emergency Shutdown and Start Up ProcedureSTEP 1 Go to your inverter. Locate the AC ISOLATOR main switch and turn the switch to the OFF position. STEP 2 At the inverter, locate the DC ISOLATOR and turn to the OFF position. STEP 3 Your inverter may have a switch marked INVERTER ISOLATOR. STEP 4 To re-start your system, follow this guide in reverse order.

Photovoltaic inverter startup instructions [PDF] Chat with us

6 FAQs about [Photovoltaic inverter startup instructions]

What is the Aurora photovoltaic inverter installation and operator's manual?

Installation and Operator’s Manual Page 10 of 108 (PVI-3.0/3.6/4.2-OUTD-x-US Rev: 2.1) FOREWORD This document contains a technical description of the Aurora Photovoltaic Inverter which provides the installer and user with the information required for its installation, operation, and use.

How do I install a PV inverter?

Please read the user manual prior to inverter site selection and installation. Connect the RS485 cable to the communication port. Switch the grid supply main Switch (AC) ON first. Switch the DC switch ON. If the voltages of PV arrays are higher than start up voltage, the inverter will turn on. The red LED power will be continuously lit.

How do I start the inverter?

Installation and operating manual Page 43 of 95 (PVI-3.8/4.6-I-OUTD Rev.: 1.5) Start-up using the side button If DC voltage is not present but the AC grid is properly connected and you wish to start the inverter, press the side button shown in Fig. 18 for more than 2 seconds.

How do I start a photovoltaic panel?

The start-up procedure is as follows: 1) Set the external DC disconnect, if present, (for the photovoltaic panels) to ON 2) Set the external AC disconnect (for the grid) to ON. Page 50 Installation and Operator’s Manual Page 50 of 108 (PVI-3.0/3.6/4.2-OUTD-x-US Rev: 2.1) are found to be within the specified range.

How many inverters can a photovoltaic system handle?

The AURORA is capable of handling 2 separate arrays. If the output of photovoltaic system exceeds the capacity of a single inverter, additional Aurora inverters can be added to the system; each inverter will be connected to an adequate section of the photovoltaic field on the DC side and to the grid on the AC side.

How does a photovoltaic inverter work?

After completing a set of electronics and safety auto-test routines, the inverter starts the grid connection process. As mentioned above, during this stage Aurora automatically tracks and analyzes the maximum power point (MPPT) of the photovoltaic field. Aurora indicates that insulation resistance was found to be too low.

Photovoltaic inverter startup instructions