Trina Solar s panel mounting process

How to Mount Trina Solar modules?

Mounting rails run parallel to the long side frame. Trina Solar has tested its modules with a number of clamps from different manufacturers, it is recommended to use fixing bolt of at least M8. The clamp shall not be malfunctioned due to deformation or corrosion during the loading process.

What temperature should Trina Solar modules be installed in?

Trina Solar recommends that the module should be installed in a working environment with an ambient temperature of -20°C to 50°C, but not exceed the temperature limit of -40°C to 85°C. The modules shall be installed in shadow-free areas throughout the year. Do not install the PV modules at a place where water damage may occur.

How to store Trina Solar modules?

Trina Solar User Manual | Vertex Series Modules For long-term storage, it is recommended to store the modules in a standard warehouse with regular inspection, and under confirming of your personal safety, reinforce the package in a timely manner if any anomalies are found. Page 15 6 class wind (the modules should be less than 12 pieces).

How to install Trina Solar module with frameless clamps?

Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load.

Can Trina Solar modules be installed in landscape or portrait orientation?

SITE SELECTION Trina Solar Modules can be mounted in landscape or portrait orientation however the impact of dirt shading the solar cells can be minimized by orienting the product in landscape. Solar module is recommended to be installed at an optimized tilt angle to maximize the energy output.

Can Trina Solar modules be installed with a grounding device?

Trina Solar modules can be installed with the use of third party listed grounding devices for grounding the metallic frames of PV modules. The devices have to be installed in accordance with the grounding device manufacturer’s specified instructions.