GoodWe photovoltaic inverter configuration gprs monitoring

How to check if a solar inverter is connected to WiFi?

The diagnosis results are possible reasons and troubleshooting suggestions. Wi-Fi Diagnose is only available if PV Master is connecting to inverter Solar-WiFi signal directly. Step 1: Tap Overview > Setting > WiFi Diagnosis. Step 2: Perform WiFi diagnosis as the following shows. Initial password: 12345678.

How do I connect my solargo inverter to WiFi?

The UI may be diferent due to the app version upgrade. Scan the QR code for latest SolarGo app user manual. Step 2 Open the WiFi settings on your phone first and connect to the inverter’s WLAN signal (Solar-WiFi***). Default password: 12345678. WiFi: Solar-WiFi******** * Represents the last 8 digits of the serial number of the inverter.

Who can install and maintain a PV inverter?

Personnel who install or maintain the equipment must be strictly trained, learn about safety precautions and correct operations. Only qualified professionals or trained personnel are allowed to install, operate, maintain, and replace the equipment or parts. The MS inverter is a single-phase PV string grid-tied inverter.

How to set a wifi password for a solar inverter?

WiFi: Solar-WiFi******** * Represents the last 8 digits of the serial number of the inverter. Step 3 Start SEMS Portal app and tap Setting Now > WiFi > Next > Modify Now to set a new WiFi password. For some dongles, the web login page will pop up, log into the web page and tap AP Settings to set a new Key and Submit.

What are the requirements for a PV inverter?

The PV modules used with the inverter must have an IEC61730 class A rating. The voltage and frequency at the connecting point should meet the on-grid requirements. Additional protective devices like circuit breakers or fuses are recommended on the AC side.

How does a PV inverter work?

The inverter is a single-phase PV string grid-tied inverter, which converts the DC power generated by the PV module into AC power for loads or the grid. The intended use of the inverter is as follows: For the grid type with neutral wire, the N to ground voltage must be less than 10V. Start or stop DC input. Only for Australia.