Fengjun 5 generator fault light flashes

How do I know if my genset controller is bad?

The genset controller provides extensive diagnos-tics by causing the status indicator light on the Con-trol Switch to blink in a coded fashion. Following a fault shutdown, the indicator light will repeatedly blink 2, 3 or 4 blinks at a time. Two blinks indicates a low oil pressure fault. Three blinks indicates a service fault.

How do I fix a faulty genset?

Turn on or reset the line circuit breaker on the genset (Page 10). Turn on or reset the line circuit breakers on the main distribution panel in the vehicle. Check engine oil level and add oil as necessary (Page 17). Drain excess oil (above dipstick Full mark.) Corrective Action: Check the second-level fault code by pressing STOP once.

How do I fix a faulty generator?

Turn the generator off and wait for at least 2 minutes before restarting. The governor has one wire to the controller and one wire for ground. If either one is loose, that will trigger this code. All you have to do is tighten the loose wire and you should be good to go.

How do I know if my Onan generator is going faster?

Another solution would be to set a lower battery boost charge rate 3 flashes, a pause and then one flash tells you that your Onan generator is going faster than 3,400 rpm. The trick here is to make sure you do not confuse 13 with 31. You can double-check by pressing the stop button 3 times in 5 seconds.

How do I know if my genset is running out of fuel?

When the genset and vehicle engine share a common fuel tank the fuel dip tubes are usual-ly arranged so that the genset will run out of fuel first. Marking the genset empty point on the fuel gauge will make it easier to tell when to stop the genset before running it out of fuel.

What should I do if my Onan genset is not working?

Corrective Action: See an authorized Onan dealer. Corrective Action: See an authorized Onan dealer. Check battery bank connections and reconnect if necessary so that the 12 volt batteries serving the genset are connected in parallel (12 volt) rather than in series (24 volt). Select a lower battery boost charge rate.