Chint solar bracket recommendation

Where can I find the Chint power system user manual?

The manual will be periodically updated or revised due to the product development or improvement. The latest version of this manual can be acquired via the website at Please read this user manual carefully before installation of the inverter.

What is the warranty policy for Chint power systems America?

The warranty policy of this product is specified in the contract; otherwise, the standard warranty is 5 years. For service, Chint Power Systems America will provide local support. For Warranty terms, please refer to the CPS America standard warranty policy in place at time of purchase.

How to set power limit in Chint Connect app?

Follow the steps below to set parameters. Open Chint Connect APP, and connect to the inverter you used. (See specific instruction in Clause 8.2.) Find ‘Power Limit’ manual in Overview page. Choose limit types to enter corresponding parameters. Please set limit values according to actual necessity and relevant local regulation.

Do I need a shade cover for a CPS inverter?

When tilted backward at ≤75° from horizontal in an outdoor environment, the CPS Shade Cover (SSC-60ST) accessory is required to be installed. See Section 9.2 for more information. Do not mount the inverter leaning forward. Do not mount the inverter upside down.

What should I do if my CPS sch100/125ktl-do inverter is not working?

Recommended solutions: Fault0020 1. Repair or replace the cables if necessary. 7.2 Clean the Air Vent Filter The inverter can become hot during normal operation. The CPS SCH100/125KTL-DO inverters use built in cooling fans to provide sufficient air flow to help in heat dissipation. Page 98 the fan tray with cable ties.

How do you mount an inverter to a bracket?

Use sling rope or bar (inserted through both lifting eye bolts) to lift the inverter onto the bracket. The minimum angle between the two sling ropes should be less than 90 degrees (Figure 3-11). Manual mounting: Two people are needed to properly lift by the handle positions marked in Figure 3-12 and mount the inverter onto the bracket.