What are the special cranes for unloading photovoltaic panels

UNLOADING, UNPACKING & STORAGE • At receipt of PV modules, verify the product details as it had been ordered. Packing list pasted outside the box contains all details including the serial no of modules. • It is recommended to unload the packing box by using forklift only.

⚫ When unloading cross-loading modules, special command is required to ensure that the forklift does not exceed the modules, and prevent damage to adjacent modules when fork is raised or placed due to.

When unloading cross-loading modules, special command is required to ensure that the forklift does not exceed the modules and prevent damage to adjacent modules when fork is raised or placed due to excessive length of forklift arms (Figure 4).

Use the right-sized forklift forks based on the pallet size. Do NOT use oversized forks. Use a 72-inch fork for 72-cell modules (LR4-72HPH-xxxM, LR4-72HBD-xxxM, and LR5-72HBD-xxxM. (LR4-60HPH-xxxM, and LR4-60HPB-xxxM). For loading from the long side (only if required for safety reasons), use a 42-inch fork.

When unloading cross-loading modules, special command is required to ensure that the forklift does not exceed the modules, and prevent damage to adjacent modules when fork is raised or placed due to excessive length of forklift arms. See other requirements below for forklift unloading considerations.

What are the special cranes for unloading photovoltaic panels [PDF] Chat with us

6 FAQs about [What are the special cranes for unloading photovoltaic panels ]

How to pack solar PV modules?

Inside the box each module is placed in vertically. Put the module into the carton from one side with protector on four corners. Citizen Solar recommends that two people should load into and remove the modules from the pack carton for solar PV modules.

How to unload & store PV modules?

UNLOADING, UNPACKING & STORAGE At receipt of PV modules, verify the product details as it had been ordered. Packing list pasted outside the box contains all details including the serial no of modules. It is recommended to unload the packing box by using forklift only.

Can PV modules be wired in series?

Modules can be wired in series to increase voltage. Connect positive terminal of one module to the negative terminal of the next module. PV modules only with the same rating should be used in series and parallel connections. Connect modules in parallel to increase current.

Can a Saatvik solar module be flammable?

Do not install modules where flammable gas may be present. Do not remove any part installed by Saatvik Solar or disassemble the module. All instructions should be read and understood before attempting to install, wire, operate and maintain the module. All PV systems must be grounded to earth.

Can you walk on a LONGi Solar PV module?

DO NOT stand or walk on PV modules. Prior to beginning installation, review the Installation Manual for LONGi Solar PV Modules. Do not carry a module alone; always use two people to lift and carry. Do not drill holes in the frame of the module.

How are crystalline silicon solar modules packed?

At Citizen Solar the standard packing -1 and standard packing -2 of crystalline silicon solar modules consists of a wooden pallet and a packing box as shown in figures below. 15.3. SPECIAL BOX PACKING

What are the special cranes for unloading photovoltaic panels